Connect with Qlixbi in 5 easy steps
01
1. Attach your regulator
After initial attachment your Qlixbi stays with you and your regulator.
02
2. Couple the cylinder
Your Qlixbi clicks in to the cylinder. No spanner, no wrench required. Your Qlixbi rotates through 360o so you can position the regulator at any position.
03
3. Turn the gas on
Lift the red lever up to open the gas flow. Use the regulator to manage the gas flow. That's it! You're ready to weld!
04
4. Turn the gas off
Push the red lever down to turn off the gas flow.
05
5. Uncouple the cylinder
Check the red lever is firmly in the down position. To uncouple your Qlixbi, grip the side and lift up and out of the cylinder.
